VTT 2013-2018 Cummins 6.7L 7-PLY Silicone Charge (Boost) Pipes

Description

VTT is proud to offer the very best EASY-TO-INSTALL charge pipe solution for the 2013-2018 Cummins platform. This system completely does away with the restrictive, and muli-connection stock charge pipe system, and replaces it with two single 7-ply, Heat Resistant, Wire reinforced silicone charge pipes rated at over 250 psi. DON’T struggle trying to install aftermarket hard pipes with 8 clamps, and cuss-worthy space to try to squeeze them in! These are molded for the perfect fit in your engine bay, while not sacrificing anything in the way of flow or size. They also completely isolate your charge air from any additional heat soak coming in from the engine or ambient heat. The stock hot side pipes have many irregular shapes and turns causing turbulence as well as carrying heat. Our hot side pipe goes from 2.75″ at the turbo immediately up to 3.50″ and continues as 3.50″ to the intercooler where it comes back down to 2.75″ for the intercooler connection. On the cold side, the pipe itself has a very irregular shape, and necks down to almost 2.5″ in spots, which can cause turbulence right before the throttle body. Our cold side pipe has completely smooth bends, and starts from 2.75″ and increases to 3.50″ immediately and stays that size all the way to the Throttle body. These silicone charge pipes resist heat and are not attached to the engine outside of the connection to the turbo outlet, and TB inlet. Thus avoiding the transfer of heat. Another huge benefit is your vehicle goes from 4 connections on each pipe to TWO. Meaning you now have half of the possible locations for a clamp to be blown off rendering you with no boost.

Installation is very easy and takes about 1-1.5 hours if you are inexperienced with working on your own truck, can take as little as 30-45 minutes if you have had it apart a few times. We can promise you, you will be thanking us if you have ever tried to install an aftermarket set of hard charge pipes in your Cummins!

Dimensions for the pipes are as follows:

Hot Side Pipe: 2.75″ on the connection to the turbo outlet opening up immediately to 3.5″ and holding 3.5″ to the intercooler inlet which is 2.75″

Cold Side Pipe: 2.75″ at the intercooler outlet opening right after up to 3.5″ all the way into the throttle body

The kit included:

• 1 – VTT Hot Side Silicone Charge pipe
• 1 – VTT Cold Side Silicone Charge pipe
• 4 – VTT T-Bolt Clamps

Fitment:

• 2013-2018 Cummins 6.7 24V Diesel